How to Make Wind Chime with Copper Pipes | Hearth and Vine (2024)

Learn how to make wind chimes with copper pipes This project was so much fun to make. Now we have a bit of musical beauty hanging on our back patio.

I love the look of copper. Especially when it ages and gets that pretty patina. I'm hoping these handmade wind chimes will eventually turn and look even more gorgeous.

Most of the supplies can be found in your local hardware store and/or craft store. Wouldn't this make a nice gift?

This post contains some affiliate links (that means if you make a purchase after clicking a link, there's no additional cost to you, but I will earn a very small commission. ) i.e. as an Amazon Associate, I earn from qualifying purchases. Click here to read my full disclosure policy.

How to Make Wind Chimes with Copper Pipes

Supplies

• 6 lengths of copper pipe - I purchased 5 feet and started with 10 inches and decreased 1/2 inch for each length
• 1 Top for hanging - I used a 6 inch cast iron drain cover from Ace Hardware.
• Nylon cording for the top and the central cord. - I used this cording from Hobby Lobby.
• Waxed thread for the pipes
• Something to act as a clapper or striker - I bought this sphere from Hobby Lobby
• A decorative piece for the sail - I used a drawer knob from Hobby Lobby. (similar to this)
• One - 1-inch keyring for hanging.
• Thin wire to secure the cords holding the drain cover.

Step 1

Start by tying the central cord to the keyring with a few square knots to make it nice and secure. Leave plenty of cording to work with, maybe 4 feet. You can cut any excess later.

Step 2

Next, cut four lengths of the cording to thread through the center of the drain and gather them together near the top of the center cord at the ring. I used 20-inch pieces for this step.

Step 3

Use some thin wire to wrap the tops of the cording sections tightly around the central cord.

Step 4

Drill a hole in the top and bottom of the sphere.

Use a long toothpick or skewer to attach to the bottom of the central cord and thread the sphere up the central line.

Step 5

Tie a couple of knots below the sphere midway along the chimes. Then slide the knob on the bottom, a few inches below the chimes, and tie a couple of knots. Cut off any excess cording.

See Also

How to Make Wind Chimes: A DIY Project for Your Home - Next Modern Home20 Soothing DIY Wind Chimes • Insteading30 Homemade DIY Wind Chimes to Make Your OwnWind Chime Parts Guide: What Makes Up a Wind Chime

Step 6

Cut your pipe into six pieces. I started with 10 inches and then decreased each next piece by 1/2 inch.

Step 7

Drill a hole through each pipe about 1/2 inch below the top. Use some painter's tape or masking tape to help the drill bit stay in place.

Step 8

Then string the copper tubes (pipes) to the edge of the drain cover in equal distant holes using waxed twine. You may want to hang the top somewhere while tying the pipes so that they hang evenly. I used a broom on a table for this step.

Hang your gorgeous wind chimes outside and enjoy. Here's a pic of the wind chimes on my front porch.

However, according to Feng Shui copper wind chimes should be placed on the North, West, or Northwest side of the house. So, my covered back porch would be a good place for it.

Still, I want to have it outside to get a nice patina so I think this spot on our patio that is located on the Northside of our house is exactly the right spot. We can sit on our back porch and enjoy the beautiful sound when the wind blows.

If you enjoy the beach and collect shells you may another DIY project: seashell and sea glass wind chime idea. It was inspired by the movie "The Choice."